Filter
Top Products
B – Command Line Interface
Set Setup Command
B-52 59042-06 A
0
Examples The following is an example of the Set Setup SNMP command:
SANbox2 #> admin start
SANbox2 (admin) #> set setup snmp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Trap Severity Options
---------------------
unknown, emergency, alert, critical, error, warning, notify, info, debug, mark
SNMPEnabled (True / False) [True ]
Contact (string, max=64 chars) [<sysContact undefined]
Location (string, max=64 chars) [sysLocation undefined]
Trap1Address (dot-notated IP Address) [10.20.71.15 ]
Trap1Port (decimal value) [162 ]
Trap1Severity (see allowed options above) [warning ]
Trap1Version (1 / 2) [2 ]
Trap1Enabled (True / False) [False ]
Trap2Address (dot-notated IP Address) [0.0.0.0 ]
Trap2Port (decimal value) [162 ]
Trap2Severity (see allowed options above) [warning ]
NTPClientEnabled Enables (True) or disables (False) the Network
Time Protocol (NTP) client on the switch. This
client enables the switch to synchronize its time
with an NTP server. This feature supports NTP
version 4 and is compatible with version 3. An
Ethernet connection to the server is required and
you must first set an initial time and date on the
switch. The synchronized time becomes effective
immediately.
NTPServerAddress The IP address of the NTP server from which the
NTP client acquires the time and date.
EmbeddedGUIEnabled Enables (True) or disables (False) the SANsurfer
Switch Manager Web applet. Changing this
parameter to False while the applet is running will
terminate the applet. The default is True.
Table B-14. System Configuration Settings (Continued)
Entry Description