Filter
Top Products
B – Command Line Interface
Set Setup Command
B-50 59042-06 A
0
system
Prompts you in a line-by-line fashion to change system configuration settings.
Table B-14 describes the system configuration fields. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
ReadCommunity Read community password that authorizes an SNMP agent
to read information from the switch. This is a write-only field.
The value on the switch and the SNMP management server
must be the same. The read community password can be up
to 32 characters excluding #, semicolon (;), and comma (,).
The default is “public”.
WriteCommunity Write community password that authorizes an SNMP agent
to write information to the switch. This is a write-only field.
The value on the switch and the SNMP management server
must be the same. The write community password can be
up to 32 characters excluding #, semicolon (;), and comma
(,). The default is “private”.
TrapCommunity Trap community password that authorizes an SNMP agent
to receive traps. This is a write-only field. The value on the
switch and the SNMP management server must be the
same. The trap community password can be up to 32
characters excluding #, semicolon (;), and comma (,). The
default is “public”.
AuthFailureTrap Enables (True) or disables (False) the generation of traps in
response to trap authentication failures. The default is False.
ProxyEnabled Enables (True) or disables (False) SNMP communication
with other switches in the fabric. The default is True.
Note: Changing the IP address will terminate all Ethernet management
sessions.
Table B-14. System Configuration Settings
Entry Description
Eth0NetworkDiscovery Ethernet boot method: 1 - Static, 2 - Bootp, 3 -
DHCP, 4 - RARP. The default is 1 - Static.
Eth0NetworkAddress Ethernet Internet Protocol (IP) address. The
default is 10.0.0.1.
Table B-13. SNMP Configuration Settings (Continued)
Entry Description