Filter
Top Products
Rev.1.01 2007.02.16
RJJ10J1643-0101
123
RAPI_UNCHANGE_0 Leaves CMP0 output unchanged even when matched in
compare 0.
RAPI_REVERSE_0 Inverts CMP0 output upon compare 0 match signal.
RAPI_L_0 Forces CMP0 output low upon compare 0 match signal.
RAPI_H_0 Forces CMP0 output high upon compare 0 match signal.
RAPI_UNCHANGE_1 Leaves CMP1 output unchanged even when matched in
compare 1.
RAPI_REVERSE_1 Inverts CMP1 output upon compare 1 match signal.
RAPI_L_1 Forces CMP1 output low upon compare 1 match signal.
RAPI_H_1 Forces CMP1 output high upon compare 1 match signal.
RAPI_OUTPUT_DISABLE Disable output.
RAPI_OUTPUT_F2 Specifies f2 output for output function.
RAPI_OUTPUT_F4 Specifies f4 output for output function.
RAPI_OUTPUT_F8 Specifies f8 output for output function.
RAPI_OUTPUT_COMPAR
E
Specifies compare output for output function.
RAPI_4BIT_COUNTER Uses 4 bit counter.
RAPI_COMPARE_MATCH
_A_STOP
Stop count when GRA compare match occur
RAPI_STOP Stop count when clear TSTART bit.
• Specifiable definition values when timer C is used (RAPI_TIMER_C specified)
(Count source) Specify one from { RAPI_F1, RAPI_F8, RAPI_F32,
RAPI_FRING_FAST }. The default value is RAPI_F1.
(Operating states
set)
Specify one from { RAPI_TIMER_ON, RAPI_TIMER_OFF }. The default
value is RAPI_TIMER_OFF.
(CMP0
0
output) Specify one from { RAPI_CMP00_DISABLE, RAPI_CMP00_ENABLE }.
The default value is RAPI_CMP00_DISABLE.
(CMP0
1
output) Specify one from { RAPI_CMP01_DISABLE, RAPI_CMP01_ENABLE }.
The default value is RAPI_CMP01_DISABLE.
(CMP0
2
output) Specify one from { RAPI_CMP02_DISABLE, RAPI_CMP02_ENABLE }.
The default value is RAPI_CMP02_DISABLE.
(CMP1
0
output) Specify one from { RAPI_CMP10_DISABLE, RAPI_CMP10_ENABLE }.
The default value is RAPI_CMP10_DISABLE.
(CMP1
1
output) Specify one from { RAPI_CMP11_DISABLE, RAPI_CMP11_ENABLE }.
The default value is RAPI_CMP11_DISABLE.
(CMP1
2
output) Specify one from { RAPI_CMP12_DISABLE, RAPI_CMP12_ENABLE }.
The default value is RAPI_CMP12_DISABLE.
(CMP0 output
inversion)
To invert CMP0 output, specify RAPI_OUTPUT_REVERSE_0. If
RAPI_OUTPUT_REVERSE_0 is not specified, “CMP0 output not
inverted” is set.
(CMP1 output
inversion)
To invert CMP1 output, specify RAPI_OUTPUT_REVERSE_1. If
RAPI_OUTPUT_REVERSE_1 is not specified, “CMP1 output not
inverted” is set.