Filter
Top Products
Rev.1.01 2007.02.16
RJJ10J1643-0101
192
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN21 Uses AN
21
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN22 Uses AN
22
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN23 Uses AN
23
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN24 Uses AN
24
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN25 Uses AN
25
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN26 Uses AN
26
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN27 Uses AN
27
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN30 Uses AN
30
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN31 Uses AN
31
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_AN32 Uses AN
32
pin for the analog input pin.
Selectable only when one-shot mode or repeat mode is used.
RAPI_P0_GROUP
Uses port P
0
group for the analog input pin. Selectable only when
sweep mode, repeat sweep mode 0, simultaneous sampling sweep
mode, delayed trigger mode 0, delayed trigger mode 1, or repeat sweep
mode 1 is used.
RAPI_P10_GROUP
Uses port P
10
group for the analog input pin. Selectable only when
sweep mode, repeat sweep mode 0, simultaneous sampling sweep
mode, delayed trigger mode 0, delayed trigger mode 1, or repeat sweep
mode 1 is used.
RAPI_P1P9_GROUP
Uses port P
1
/P
9
group for the analog input pin. Selectable only when
sweep mode, repeat sweep mode 0, simultaneous sampling sweep
mode, delayed trigger mode 0, delayed trigger mode 1, or repeat sweep
mode 1 is used.
RAPI_P9_GROUP
Uses port P
9
group for the analog input pin. Selectable only when
sweep mode, repeat sweep mode 0, simultaneous sampling sweep
mode, delayed trigger mode 0, delayed trigger mode 1, or repeat sweep
mode 1 is used.
RAPI_AD_ON Sets the A/D converter to start operating.
RAPI_AD_OFF Sets the A/D converter to stop operating.
(R8C)
RAPI_AN0 Uses AN
0
pin for the analog input pin.
RAPI_AN1 Uses AN
1
pin for the analog input pin.
RAPI_AN2 Uses AN
2
pin for the analog input pin.
RAPI_AN3 Uses AN
3
pin for the analog input pin.