Filter
Top Products
Rev.1.01 2007.02.16
RJJ10J1643-0101
128
(M16C)
Specify a pointer to the array in which the set value for the waveform generation
control register or waveform generation register is stored.
[0]: Specify the set value for waveform generation control register 0.
[1]: Specify the set value for waveform generation control register 1.
[2]: Specify the set value for waveform generation control register 2.
[3]: Specify the set value for waveform generation control register 3.
[4]: Specify the set value for waveform generation control register 4.
[5]: Specify the set value for waveform generation control register 5.
[6]: Specify the set value for waveform generation control register 6.
[7]: Specify the set value for waveform generation control register 7.
[8]: Specify the set value for waveform generation register 0 in 16 bits.
Specify the comparison value of channel 0 in 16 bits.
[9]: Specify the set value for waveform generation register 1 in 16 bits.
Specify the comparison value of channel 1 in 16 bits.
[10]: Specify the set value for waveform generation register 2 in 16 bits.
Specify the comparison value of channel 2 in 16 bits.
[11]: Specify the set value for waveform generation register 3 in 16 bits.
Specify the comparison value of channel 3 in 16 bits.
[12]: Specify the set value for waveform generation register 4 in 16 bits.
Specify the comparison value of channel 4 in 16 bits.
[13]: Specify the set value for waveform generation register 5 in 16 bits.
Specify the comparison value of channel 5 in 16 bits.
[14]: Specify the set value for waveform generation register 6 in 16 bits.
Specify the comparison value of channel 6 in 16 bits.
[15]: Specify the set value for waveform generation register 7 in 16 bits.
Specify the comparison value of channel 7 in 16 bits.
To specify the set value for each waveform generation control register that is an
array element, the following definition values can be set. To specify multiple
definition values at the same time, use the symbol “|” to separate each specified
value.
RAPI_SINGLE Selects single-phase waveform output mode.
RAPI_SR Selects SR waveform output mode.
RAPI_PHASE_DELAYED Selects inverted waveform output mode.
RAPI_OUT_INIT_0 Outputs a 0 as the initial output value.
RAPI_OUT_INIT_1 Outputs a 1 as the initial output value.
RAPI_OUTPUT_
REVERSED
Uses an output inversion facility.
RAPI_RELOAD_WITH_
RESET
Selects a reset of the base timer as the timing with which the
G1P0J register value is reloaded.
RAPI_RELOAD_WITH_
WRITE
Selects a write to the base timer as the timing with which the
G1P0J register value is reloaded.
• Specifiable definition values for waveform generation control registers 0–7