Filter
Top Products
Rev.1.01 2007.02.16
RJJ10J1643-0101
127
(Interrupt) If overflow interrupt requests are enabled, specify RAPI_OVERFLOW. If
compare match A, compare match B, compare match C, or compare
match D interrupt requests are enabled, specify
RAPI_COMPARE_MATCH_A, RAPI_COMPARE_MATCH_B,
RAPI_COMPARE_MATCH_C, or RAPI_COMPARE_MATCH_D,
respectively. When not specifying interrupts, select “No interrupt
requests.”
(Counter clear) To specify GRA compare match for the cause of counter clear, specify
RAPI_COUNT_CLEAR_A.
• Specifiable definition values when timer RD is used (RAPI_TIMER_RD0 to
RAPI_TIMER_RD4 specified)
(Count source) Specify one from [RAPI_TRD_F1, RAPI_TRD_F2, RAPI_TRD_F4,
RAPI_TRD_F8, RAPI_TRD_F32, RAPI_TRD_F40M]. The default is
RAPI_TRD_F1.
(Operating
states set)
Specify one from { RAPI_TIMER_ON, RAPI_TIMER_OFF }. The default
value is RAPI_TIMER_OFF.
(Interrupt) If overflow interrupt requests are enabled, specify RAPI_OVERFLOW.
Similarly, if compare match A, compare match B, compare match C, or
compare match D interrupt requests are enabled, specify
RAPI_COMPARE_MATCH_A, RAPI_COMPARE_MATCH_B,
RAPI_COMPARE_MATCH_C, or RAPI_COMPARE_MATCH_D,
respectively. If no interrupts are specified, “No interrupt request” is set.
(Counter clear) To specify GRA, GRB, GRC, or GRD compare match for the cause of
counter clear, specify RAPI_COUNT_CLEAR_A,
RAPI_COUNT_CLEAR_B, RAPI_COUNT_CLEAR_C, or
RAPI_COUNT_CLEAR_D, respectively.
(Synchronization) If the timer is synchronized on channels 0 and 1, specify
RAPI_TIMER_SYNC. If synchronization is not specified, “Channels 0 and
1 operate independently” is set.
[data2]
(M16C)
Specify a pointer to the array in which the interrupt priority level is stored.
[0]: Specify the IC/OC base timer interrupt priority level (0–7).
[1]: Specify the IC/OC interrupt 0 priority level (0–7).
[2]: Specify the IC/OC interrupt 1 priority level (0–7).
(R8C)
Specify a pointer to the array in which the interrupt priority level is stored.
[0]: Specify the timer C interrupt priority level (0–7).
[1]: Specify the compare match 0 interrupt priority level (0–7).
[2]: Specify the compare match 1 interrupt priority level (0–7).
(H8/300H)
Specify 0.
[data3]