Filter
Top Products
Copy Paper
179
8
*8
The optional B4/8
1
/
2
" × 14" tray unit is required to load B4/8
1
/
2
" × 14" size paper.
(2,500 sheets can be loaded in this tray.)
*9
When loading paper, make sure the stack height does not exceed the lower limit
mark of the paper tray. The amount of paper that can be set is 10 mm/100 sheets ap-
proximately.⇒ p.116 “B Loading Paper”
*10
It is recommended to place one sheet at a time.
*11
When loading translucent papers, set the paper direction according to fiber flow.
Important
❒ If you use damp or curled paper, a misfeed may occur.
Note
❒ When loading paper in the paper trays 1-3, place the copy side face down.
❒ When loading paper in the large capacity tray (LCT), place the copy side face
down.
❒ When loading paper in the bypass tray, place the copy side face up.
❒ When you use the bypass tray, it is recommended to set the copy paper direc-
tion to L.
❒ Do not use paper for inkjet printers.
❒ When you load OHP transparencies, check the front and back of the sheets,
and place them correctly, or a misfeed might occur. Set the paper direction to
L. ⇒“Copying from the Bypass Tray” in the Copy Reference.
❒ When you use OHP transparencies, shuffle them for each use.
❒ If multiple sheet feeding occurs, load sheets one by one.
❒ When you load label paper, set the paper direction to K.
❒ If you load paper of the same size in the same direction in two or more trays,
the machine automatically shifts to the other tray when the first tray in use
runs out of paper. This function is called Auto Tray Switching. (However, if
the Paper Type of one tray is recycled or special paper, the settings of the oth-
er trays must be the same for the Auto Tray Switching function to work.) This
saves interrupting a copy run to replenish paper when making a large
number of copies. ⇒ “General Features
1
/
5
- Auto Tray Switching” in the
Copy Reference, p.79 “Tray Paper Size: (Tray 2,3)”
MartiniC1_GBzen2_FM.book Page 179 Friday, April 19, 2002 2:18 PM