Filter
Top Products
Setting Up the Printer
24
2
L
Push the cable of the connected
harness into the groove for the ca-
ble.
M
Attach cover 1 (A
AA
A) and secure cov-
er 1 to the printer fastening the
screw (B
BB
B).
Note
❒ Make sure the core of the screw
is pulled out slightly before in-
serting it.
N
Attach cover 2 and secure cover 2
to the printer inserting the two
screws.
O
Turn the adjuster at the center
bottom of the paper feed unit
clockwise until it touches the
floor.
P
Put the seal directly below the pa-
per size display on the front of the
paper feed tray.
Note
❒ If PS440 is installed, use the tray
number seal included with the
printer.
❒ If PS420 is installed, use the pa-
per size seal included with the
printer.
❒ After installing all options, print
a configuration page to confirm
the installation. If the new de-
vice is listed in the column of
configuration options, then it
has been properly installed. For
more information, see P.54
“Printing a Configuration Page”.
ZAEP091E
1
2
ZAEP671E
ZDEP060E
ZAEP100E