Filter
Top Products
Installing Options
31
2
Installing Bypass Tray Type
270
Preparation
The installation procedure for in-
stalling the bypass tray when the
duplex unit is not yet installed is
described below.
If the duplex unit is already in-
stalled, remove the holder cover.
Note
❒ If you install the duplex unit and
the bypass tray unit, the duplex
unit must be installed first.
❒ If the duplex unit is already in-
stalled, perform steps A to C and
then go to step H.
A
Confirm that the box contains the
following items.
1.
Holder
2.
Socket screws (2 pcs)
3.
Wrench
• Installation Guide
Note
❒ If the duplex unit is already in-
stalled, the holder is no longer
required.
B
Turn off the printer, and remove
all cables and cords from the
printer.
C
Remove the adhesive tape and the
packing materials.
Important
❒ Do not remove the adhesive
tape (A) holding the tray and
cable until the connector is at-
tached in step K.
Note
❒ If the duplex unit is already in-
stalled, go to step H.
3
2
1
ZAEP430E
ZAEP420E
ZAEP530E