Filter
Top Products
Loading Paper
49
2
Loading Paper in Bypass Tray
Type 270
Note
❒ Paper sizes supported by the by-
pass tray are in the approximate
range of 90 - 297 mm (3.54" - 11.69")
in width, and 148 - 432 mm (5.83" -
17.00") in length.
❒ To specify a custom size with the
operation panel, see "Specifying a
Custom Paper Size for the Bypass
Tray" in the Printer Reference in-
cluded as a PDF file on the CD-
ROM.
❒ If you load a custom or unique pa-
per size, set the paper size using
the operation panel.
A
Open the bypass tray.
B
Lift the paper guide lever.
Important
❒ If the paper guides do not match
the paper size, skew images or
paper misfeeds might occur.
Note
❒ Swing out the extender to sup-
port paper sizes longer than A4
short-edge feed (Metric version)
or 8
1
/
2
" × 11" short-edge feed
(Inch version).
C
Load the paper and adjust the pa-
per guides to the sides of the pa-
per.
Important
❒ Confirm the print side of OHP
transparencies. Some OHP
transparencies can be printed
on only one side.
Note
❒ Do not stack paper over the lim-
it mark. If you do, skew images
or paper misfeeds might occur.
❒ When you set a custom size or
thick paper in the bypass tray,
do not stack paper above the
lower limit mark of the bypass
tray.
❒ To avoid paper multi-feeds,
shuffle sheets before setting
them in the tray.
❒ Load the paper face down onto
the tray.
ZAEY040E
ZAEY210E
ZAEY220E