Filter
Top Products
Key Operator Settings
82
6
Line Type
You must register the Line Type before
you connect the machine to the line.
Note
❒ By default, Line Type is set to
“Tone”.
❒ This function is not available in
some areas.
❒ If you do not know the type of line
you are connected to, select "Tone"
and dial a trial number. If the con-
nection was successful, your Line
Type is "Tone", if it did not, set the
Line Type to "Pulse" and dial a trial
number. If the connection was suc-
cessful, your Line Type is "Pulse".
Limitation
❒ If you do not correctly set the Line
Type, you will be able to receive
messages, but you may not be able
to send them.
To register the Line Type, perform the
following procedure.
Note
❒ You can edit the registered Line
Type by performing the steps for
registering the Line Type in the fol-
lowing procedure.
A
Press the {
{{
{User Tools}
}}
} key.
B
Press 0
00
0 or 1
11
1 until "4. Fax Fea-
tures" is displayed.
C
Press the {
{{
{OK}
}}
} key.
D
Press 0
00
0 or 1
11
1 until "6. Key Op.
Tools" is displayed.
E
Press the {
{{
{OK}
}}
} key.
Note
❒ If the key operator code is regis-
tered and turned on, enter the
key operator code and press the
{OK} key.
F
Press 0
00
0 or 1
11
1 until "7. Line Type"
is displayed.
G
Press the {
{{
{OK}
}}
} key.
H
Press 0
00
0 or 1
11
1 and select "Tone" or
"Pulse".
I
Press the {
{{
{OK}
}}
} key.
"Function Accepted" is displayed
on the screen.
J
Press the {
{{
{Cancel}
}}
} key on each
display until you reach the stand-
by display.