Filter
Top Products
HighWire HW400c/2 User Reference Guide Rev 1.0
keystroke will stop the countdown and drop into the U-boot debug
shell.
baudrate Baud rate of the HW400c/2 console (debug) port
unit’s MAC address.
he MAC address is assigned by SBE at the time of manufacture, stored in non-volatile memory, and
ress will be ignored.
n dot notation. If not used,
ing bootp, this
address is ignored.
The tftp server’s IP address in dot notation. If not used, should be set
to 0.0.0.0 for clarification. When using bootp, this address is
ot used, should
tp, this address is
etmask This unit’s netmask in dot notation. If not used, should be set to
0.0.0.0 for clarification. When using bootp, the mask is ignored.
Fixed environment variables.
These variables will be displayed and cannot be changed.
ard).
serial
Destination of the HW400c/2’s standard output (terminal screen).
Default= Cannot be deleted (debug port).
stderr Destination of the HW400c/2’s standard error (console error
messages). Default=serial (debug port).
ethact Active MAC port. Default=
mv_eth0
ethaddr This
T
must not be altered. Any attempt to change the MAC add
ipaddr This unit’s static IP address (if used) i
should be set to 0.0.0.0 for clarification. When us
serverip
ignored.
gatewayip The gateway system’s IP address in dot notation. If n
be set to 0.0.0.0 for clarification. When using boo
ignored.
n
stdin Source of the HW400c/2’s standard input (keybo
Default= (debug port).
stdout
October 10, 2006 Copyright 2006, SBE, Inc. Page 78