Filter
Top Products
BACK CONTROL PANEL
13
1. Air Pressure Gauge: Indicates the PSI reading for the
downward pressure of the top pull roller. The standard
setting for the normal operation is 35-55 PSI.
2. Air Regulator Knob: Adjusts the downward pressure
of the top pull roller. Turn clockwise to increase the
pressure.
3. Roller Up/Down Switch (Rear, Top): Press the
switch up to raise the roller. Press the switch down to
lower the roller.
4. Reset Button: Press this button to reset the material
total usage counter to zero. Totalizer Display must be
showing to be able to zero out.
5. Ratemeter/Totalizer Button: Pressing the button will
toggle between the roller speed readout or total material
usage. Press this button to track and display the total
number of feet or meters run in a given period, which
can help to monitor film usage. The total will be stored
even after the laminator is turned off and adds to the
total whenever the bottom main roller is turning. The
corresponding LED will be lit when the totalizer is
being used.
6. Ratemeter/Totalizer Readout: Displays the rate of
speed of the main rollers in either feet or meters per
minute, or displays the total number of feet or meters
run in a given period.
Figure 6. Back Control Panel