Filter
Top Products
ENVIRONMENT CONDITIONS
6
The following environmental conditions are ideal for
the best operation of the laminator.
AMBIENT TEMPERATURE
The best temperature for the SEAL Image 6500 is
between 50°F and 86°F (10°C and 30°C).
Do not expose the laminator to direct sunlight as output
quality may be affected.
RELATIVE HUMIDITY
For best results, the ambient relative humidity for the
SEAL Image 6500 should be between 70-90% non-con-
densing. Too much humidity will affect the prints being
laminated causing problems with film adhesion.
WATER AND MOISTURE
If the laminator is installed in a damp room or near water,
the electrical power supply must be in accordance with the
standards prevailing in the country concerned.
SURROUNDINGS
Install the laminator in surroundings that are as clean and
dust-free as possible in order to obtain the highest quality
output.
The background dust level must not exceed that found in
a typical office/computer room environment.
The materials that are used on this laminator can have an
electrostatic charge and will attract dust, adversely affect-
ing the output.
POWER SUPPLY
Connect the laminator in accordance with the details
given on the identification plate attached to the rear of the
laminator. Refer also to the Technical Specifications page
for more information.