Filter
Top Products
DECALING (PRESSURE-SENSITIVE)
26
This process involves applying a cold pressure-sensi-
tive over-laminate to the top and a cold pressure-
sensitive mounting adhesive to the bottom of a
graphic. This process can be used to create self-
adhesive images for mounting down onto various
substrates. After performing this process, follow
the Mounting Instructions in the manual to apply
the decal to a substrate.
MEDIA: Ink Jet, Electrostatic, and Photographic
FILMS:
-- -- -- Top Unwind Shaft: Pressure-sensitive over-laminate
____ Bottom Unwind Shaft: Pressure-sensitive mounting
adhesive
LAMINATOR SETTINGS:
Front Control Panel
Top Roller Temp.: OFF
Bottom Roller Temp.: OFF
Main Roller Pressure: 35-40 PSI
Cooling Fan: OFF
Back Control Panels
Pull Rollers: Down
Pull Roller Pressure: 35-40 PSI
Pull Clutch Tension: 40-60 PSI
Motor Control Panel
Motor Direction: Reverse
Motor Speed Setting: 3-5 FPM (1-1.5 MPM)
WEBBING SETTINGS
Web Tension Top: Light
Web Tension Bottom: Light
Chill Idlers: Over 1st/Over 2nd
Shim Wheel Settings: -1/16" (-2mm)
Shim Wheel Settings: -1/16" (-2mm)
NOTE: Pressure-sensitive films, not requiring heat, can
be run from the front or rear of the laminator
NOTE: When using Mounting Adhesive on the back of
images, it is best to run over both idlers. Running the
film under the second idler may cause the backing to
separate from the release liner.
Figure 22. Webbing for Decaling
(Pressure-sensitive films)
Top
Main Roller
Top
Pull Roller
Front Top
Supply Shaft
Rear Top
Supply Shaft
Bottom
Main Roller
Bottom
Pull Roller
Chill
Idler
Shim Wheel
Print Guide
Front Table
Front
Bottom
Wind-up
Rear
Bottom
Wind-up
Rear
Bottom
Supply
Shaft
Front
Bottom
Supply
Shaft
Rear
Roll
Easel
Front
Roll
Easel
Rear
Top
Wind-up
Front Top
Wind-up
Top
Idler
Rear Table
Covered
Foot
Switch
Fan
Tube
Bott
Idler
Note: Move Choice of Table
to Rear of Laminator for
Feeding Prints.
Note: Remove Bottom Rear
Wind-up Idler for webbing
ease and to prevent adhesive
from sticking onto it when
webbing.
Hint: Lower top main roller
onto films during webbing
to pull film taut. Raise top roller
after tracking is correct.
Front
Rear
Shim Wheel
Covered
Foot
Switch
Chill
Idler
Bott
Idler