Filter
Top Products
TOP MOTOR CONTROL PANELS
15
Figure 8. Top Motor Control Panel
The Motor Control Panels are centrally located on
the top of both side cabinets. This location provides
easy access from all sides of the laminator. Right- or
left-handed operators can use either panel to make
speed or direction processing adjustments from the
front or rear of the laminator. A change made to
either panel affects the settings of both panels.
1. Speed Adjustment Knob
Use this knob to adjust the speed of the roller rotation.
Turn the knob clockwise to increase the speed of the roller
rotation and counter-clockwise to decrease the speed. The
speed of the rollers is continuously adjustable between 0
and 15 ft./min. (0 and 4.5m/min.). The roller speed can
be viewed in the top display readouts on both the front
and back control panels.
2. Reverse Roller Direction Switch
Pressing this switch runs the rollers in the reverse direction
when standing at the front of the laminator. This direction
will be used when processing cold pressure-sensitive films
from the rear of the laminator through the pull rollers.
3. Motor Stop Switch
Pressing this switch stops the roller rotation.
NOTE: You must press this switch before you can press
the opposite direction switch.
4. Forward Roller Direction Switch
Pressing this switch runs the rollers in the forward direc-
tion when standing at the front of the laminator.