Filter
Top Products
Connecting External Monitors
132
Connecting External Devices
Images of 50P/50i/25P are output as PAL signals,
those of 59.94P/59.94i/29.97P are output as
NTSC signals, and those of 23.98P are output as
2-3 pulled-down NTSC signals.
SDI OUT connector (BNC type)
The connector is set at the factory to output an HD
SDI signal.
Using “YPbPr/SDI Out Select” (page 122) of the
VIDEO SET menu, you can change the setting so
that it outputs an SD SDI signal. (The HD/SD
switching becomes valid also on the
COMPONENT OUT connector in
synchronization.)
Use a commercially available 75-ohm coaxial
cable for connection.
To display the menus and status information on
the connected monitor
Set “YPbPr/SDI Out Display” (page 122) of the
VIDEO SET menu to “On.”
Note
If input/output at the i.LINK (HDV) connector
are enabled (page 135), no signal is fed out from
the SDI OUT connector.
COMPONENT OUT connector (mini-D
connector)
The connector is set at the factory to output HD
analog component signals for monitoring.
Using “YPbPr/SDI Out Select” (page 122) of the
VIDEO SET menu, you can change the setting so
that it outputs down-converted analog component
signals for monitoring. (The HD/SD switching
becomes valid also on the SDI OUT connector in
synchronization.)
Use the supplied component video cable for
connection.
To display the menus and status information on
the connected monitor
Set “YPbPr/SDI Out Display”(page 122)of the
VIDEO SET menu to “On.”
MONITOR OUT connector (BNC type)
The connector outputs down-converted SD
analog composite signals for monitoring.
Use a commercially available 75-ohm coaxial
cable for connection.
To display the menus and status information on
the connected monitor
Set “Video Out Display” (page 122) of the
VIDEO SET menu to “On.”
S VIDEO connector (S connector)
The connector outputs YC separate signals for
monitoring.
Use a commercially available S video cable for
connection.
To display the menus and status information on
the connected monitor
Set “Video Out Display” (page 122) of the
VIDEO SET menu to “On.”
AUDIO OUT CH1/CH2 connectors (RCA
phono jacks)
The connectors output recording/playback audio
signals of the respective channels.
Use a commercially available audio cable for
connections.