Filter
Top Products
Chapter 3. Identifying the Components
May 2002 T-38324-A Page 3-5
Tool cables are available in lengths of:
• 3 ft / 0.91 m (part number 51-3066-0003)
• 6 ft / 1.83 m (part number 51-3066-0006)
•
10 ft / 3.05 m (part number 51-3066-0010)
• 15 ft / 4.57 m (part number 51-3066-0015)
• 30 ft / 9.14 m (part number 51-3066-0030)
•
50 ft / 15.24 m (part number 51-3066-0050)
• 70 ft / 21.34 m (part number 51-3066-0070)
RS-422 Connector
The 10-position male asynchronous RS-422 serial I/O connector enables the controller to receive a
barcode read by a scanner. The RS-422 communications currently supports the Siemens 3964R
barcode protocol.
Ethernet Connector
The RJ-45 Ethernet connector enables the controller to communicate and send data to and from a host
device on the same Local Area Network (LAN) using standard Ethernet protocols (Transmission
Control Protocol/Internet Protocol, TCP/IP). Refer to Chapter 4. Installing the CS4000 Mini
Controller with Ethernet for details.
Printer/Barcode Connector
The nine-position asynchronous RS-232-compatible serial output connector allows you to use a
printer. The printer can be used to generate hard copies of torque, or torque and angle readings, system
configuration information, or statistical data upon command from the controller. This port can also be
used to receive barcode information.
SDLC I/O Network Connector
The 10-position female RS-485 connector enables a permanent network connection to and from the
controller, other controllers in the network and a permanently connected computer.
RS-232 Connector
The nine-position asynchronous RS-232 compatible serial output connector allows you to use a laptop
computer. The laptop computer can be running the Visual Supervisor software program, the Ethernet
Interface Flash Utility, or other program that allows you to program (also referred to as ‘flash’) the
latest Device Control Module and Tool Control Module firmware into the controller.
Ground Fault Circuit Interrupter
The 250V Ground Fault Circuit Interrupter (GFCI) (part number 13-20-2000) is a safety device,
approved by Underwriters Laboratories, that is designed to protect you from potentially dangerous
electrical shock.