Filter
Top Products
Chapter 5. Setting Up the Ethernet
May 2002 T-38324-A Page 5-7
The TINI Ethernet Flash Utility connects to the Ethernet interface card, via the COM
port you specified in Step 9. When the communications connection is successful, the
yellow LED (LED6 on the Ethernet interface card) stops blinking and the flash utility
begins flashing the application file to the Ethernet interface card. Refer to Table 3-1
on page 3-15 for a complete description of the LEDs on the Ethernet interface card.
If an error occurs and the connection to the Ethernet interface card cannot be
established, the message shown in Figure 5-8 is displayed.
Figure 5-8. Error Message Displayed when the Attempted
Connection Fails
When you receive this error message, click OK and a new window is displayed. See
Figure 5-9.
Figure 5-9. Error Message Following An
Unsuccessful Flash Attempt
When the connection to the Ethernet interface card fails, the flash process also fails.
When you receive this message, click OK and a new window is displayed. See
Figure 5-10.
Figure 5-10. Second Error Message Following An Unsuccessful
Flash Attempt