Filter
Top Products
CHAPTER 3
PARTS REPLACEMENT AND RELATED ADJUSTMENTS
This chapter describes disassembly and reassembly procedures.
Please take note of the following.
1. ALWAYS disconnect the power cord from the AC outlet before beginning a disassembly or reassembly
procedure.
2. Except where otherwise stated, the reassembly procedure is the reverse of the disassembly procedure.
3. Coat screw heads with locking sealant after completion of reassembly.
4. Refer to Chapter 4 Section 2 for important information about lubrication requirements.
Note :The printer has no adjustable parts.
1. Upper Casing Unit ............................................................................................... 35
2. Control-Panel Board ........................................................................................... 36
3. Printer Mechanism .............................................................................................. 37
4. Main PCB, Interface PCB .................................................................................... 38
5. Power Unit ........................................................................................................... 39
6. Fuse ...................................................................................................................... 39
7. Printhead Unit...................................................................................................... 40
8. Feed Motor Assembly ......................................................................................... 40
9. Detectors .............................................................................................................. 41
10. Label sensor ..................................................................................................................... 41
3