Star Micronics XB-2420 Printer User Manual


 
Check
Possible remedy
Is thepapercaughtup around
It isrecmrunended toskiparoundtheperforation. If you
the perforation?
cannoLsetonthe Multi-partmode withtheEDS switch.
Are you trying to feed paper
You can only feed paper in this way the printer is eff-
using the front psnel buttons
line. Set the printer off-line and then feed paper.
while the ON
LINEindicator
illuminated?
.Is the paper too thick? There are limits to thethickness of paper that can be fed
in this way. Try with thinner paper.
If the ASF is not operatingor is not feedingpaper correctly,check the
following:
Check
Possible remedy
Has the correct ASF option Select correct option.
been selected with the EDS
switch?
Is the release lever set to the The release lever should be set to the single-shem.t
~ position?
position.
Is the ASF correctly Make sure that theASF isproperlyseated ontheprinter.
mounted?
Is paper caught up new the Stopprinting, remove thejamrn
ed sheet (you may have
print head? to remove the ASF for this), and continue.
Are the left and right guides If the left and right guides are too close together, the
too close together? paper will not feed smoothly. Move them a little further
apart to allow the paper to feed freely.
Is there toomuchpaperinthe
The ASF’S paper feed hopper and stacker can hold
paperfeedhopperorstacker? between 100to 150sheets each. Make sure that there is
no more paper than this in either the hopper or stacker.
Was the paper fanned before
If this is not done, paper jams may occur. Remove the
being fed into the ASF? stack of paper from the ASF and fan it before
reinserting.
Has the paper been used al-
1
Only
new, uncreased paper should be used with the
readv or is it creased? ASF.
Are you trying to feed paper
You can only feed paper in this way the printer is eff-
using the front panel buttons line. Set the printer off-line and then feed paper.
while the ON
LINEindicator
illuminated?
Is the paper too thick or too
There are limits to the thickness of paper that can be fed
fiin?
in this way. Try with different paper.
147