Filter
Top Products
Appendix H Service Processor Commands 179
TABLE H-30 lists the arguments for this subcommand.
Note – If you change the default addresses of JNET using this command and then re-install
the platform operating system or reset the SP through the subcommand
sp reset to default-settings , you must re-issue the subcommand
sp set jnet to re-establish the JNET connection.
Otherwise, the connection will be out-of-sync (one address will be modified and one
will be re-set to the default address.)
Return Codes
TABLE H-31 lists the return codes for this subcommand.
TABLE H-30 Arguments for Subcommand sp set jnet
Argument Description
{-p | --platform} Specifies the IP address for the platform.
{-s | --sp} Specifies the IP address for the SP.
TABLE H-31 Return Codes for Subcommand sp set jnet
Return Code ID Description
NWSE_Success 0 Command successfully completed.
NWSE_InvalidUsage 1 Invalid usage: bad parameter usage, conflicting options
specified.
NWSE_NoPermission 6 Not authorized to perform this operation.
NWSE_NoMemory 8 Insufficient memory.
NWSE_Busy 9 Device or resource is busy.
NWSE_HostDown 14 Host is down.