Filter
Top Products
Appendix H Service Processor Commands 187
Return Codes
TABLE H-43 lists the return codes for this subcommand.
BIOS POST Codes
TABLE H-44 lists the POST codes for the Phoenix BIOS.
TABLE H-43 Return Codes for Subcommand sp get port80
Return Code ID Description
NWSE_Success 0 Command successfully completed.
NWSE_InvalidUsage 1 Invalid usage: bad parameter usage, conflicting
options specified.
NWSE_NoPermission 6 Not authorized to perform this operation.
NWSE_NoMemory 8 Insufficient memory.
NWSE_ServiceNotAvailable 24 Requested service is not available.
TABLE H-44 BIOS POST Codes
POST Code Description
02 Verify real mode
03 Disable non-maskable interrupt (NMI)
04 Get CPU type
06 Initialize system hardware
07 Disable shadow and execute code from the ROM
08 Initialize chipset with initial POST values
09 Set IN POST flag
0A Initialize CPU registers
0B Enable CPU cache
0C Initialize caches to initial POST values
0E Initialize I/O component
0F Initialize the local bus IDE
10 Initialize power management
11 Load alternate registers with initial POST values
12 Restore CPU control word during warm boot