Filter
Top Products
Appendix H Service Processor Commands 199
TABLE H-55 lists the arguments for this command.
Note – If you change the default addresses of JNET using this command and then
re-install the platform operating system or reset the SP by running the subcommand
sp reset to default-settings, you must re-issue the subcommand
sp set jnet to re-establish the JNET connection.
Otherwise, the connection will be out-of-sync (one address will be modified and one
will be re-set to the default address).
TABLE H-55 Arguments for Subcommand sp reset
Argument Description
{-a | --all} Resets all SP settings to their default configuration.
When the SP reboots, the settings are reset to their default values.
{-c | --config} Resets other system configuration settings to their default
configuration.
When the SP reboots, the system settings are reset to their default
values.
{-n | --network} Resets network settings to their default configuration.
When the SP reboots, it has no network capabilities or host name.
Its NFS mounts fail and you cannot log into the SP remotely
through ssh.
Set up the network configuration for the SP through the operator
panel to restore network functions.
Set the host name for the SP in order to refer to the SP by name
and set up the file resolv.conf in order to refer to other
systems by name instead of by dot-quad IP addresses.
This option deletes all the network files in the directory /pstore.
{-s | --ssh} Resets SSH settings to their default configuration.
When the SP reboots, new ssh public and private keys are
generated. Using ssh to access the SP from a remote system that
had previously logged into the SP causes a failure with a message
about the “Remote Host Identification” changing because the ssh
key on the SP has changed.
The remote system must delete its ssh public key entry for the SP
in order to ssh into the SP successfully. This option deletes all the
files in the directory /pstore/ssh/.
{-u | --users} Resets user authentication settings to their default configuration.
When the SP reboots, all user accounts will have been deleted
and you cannot log into the SP remotely through ssh.
[-W | --nowait] Reboots the SP immediately.