Filter
Top Products
Appendix H Service Processor Commands 181
SP Set Locatelight Subcommand
Description: Sets the state of the locatelight switch (which describes the state of the
front and rear panel identification lights).
Format
Command format:
sp set locatelight {blink | off}
Return Codes
TABLE H-34 lists the return codes for this subcommand.
TABLE H-34 Return Codes for Subcommand sp set locatelight
Return Code ID Description
NWSE_Success 0 Command successfully completed.
NWSE_InvalidUsage 1 Invalid usage: bad parameter usage, conflicting
options specified.
NWSE_RPCTimeout 2 Request was issued, but was not serviced by the
server. RPC procedure timed out and the request may
or may not have been serviced by the server.
NWSE_RPCNotConnected 3 Unable to connect to the RPC server.
NWSE_NoPermission 6 Not authorized to perform this operation.