Filter
Top Products
180 Sun Fire V20z and Sun Fire V40z Servers, Server Management Guide • May, 2004
SP Locate Light Subcommands
The subcommands in TABLE H-32 manage the locatelight switch.
SP Get Locatelight Subcommand
Description: Reads the value of the locatelight switch (which represents the state of
the front and rear panel identification lights). The possible states are blinking or off.
Format
Command format:
sp get locatelight
Return Codes
TABLE H-33 lists the return codes for this subcommand.
TABLE H-32 SP Locatelight Subcommands
Subcommand Description
sp get locatelight Reads the value of the locatelight switch (which represents
the state of the front and rear panel identification lights).
sp set locatelight Sets the state of the locatelight switch.
TABLE H-33 Return Codes for Subcommand sp get locatelight
Return Code ID Description
NWSE_Success 0 Command successfully completed.
NWSE_InvalidUsage 1 Invalid usage: bad parameter usage, conflicting
options specified.
NWSE_RPCTimeout 2 Request was issued, but was not serviced by the
server. RPC procedure timed out and the request
may or may not have been serviced by the server.
NWSE_RPCNotConnected 3 Unable to connect to the RPC server.
NWSE_NoPermission 6 Not authorized to perform this operation.