Filter
Top Products
56
Programming the remote operation ID
The remote operation ID is used to access your answering device and listen to your messages in common
memory.
Choose any 3-digit number except a number using digits 0 or 7.
Make sure that the first 2-digits of the remote operation ID are different from the junk mail prohibitor ID (p. 41)
and the mailbox password (p. 50).
1
Press (MENU).
2
Press K, then A@.
3
Press (START/SET).
4
Enter the desired number.
5
Press (START/SET).
6
Press (MENU).
ID=111
REMOTE ANS ID
SYSTEM SET UP
(MENU)
(START/SET)
Dial keypad
1. Call your unit.
2. Enter the remote operation ID
∆∆∆ during the greeting
message.
3. Press the remote command key
(refer to the right) within 4
seconds.
or
Wait for 4 seconds. All the
recorded messages will be played
back.
Answering Device Remote Operation
Remote Command
Skips the greeting message
Repeats a message
Skips a message
New message playback
All message playback
Room monitor
Re-records a greeting message
Stops re-recording of a
greeting message
Erases a specific message
Erases all messages
Changes to the TEL mode
Pager alert for ANS—ON
Pager alert for ANS—OFF
Key
`
A
B
D
E
F
G
I
JD
JE
H`
HA
HB