Filter
Top Products
Section 2: Installation and Setup
2-20 Christie DS+60/DW30/Matrix 3000 User’s Manual 013-100149-02 Rev. 1 (01/07)
Plug the line cord to the AC receptacle located on the right hand side of the projector
and the three-pronged end into a grounded AC outlet (Figure 2.22). The input voltage
to the projector must be capable of 100 – 240 VAC. See also Section 6 –
Specifications for complete details on all power requirements.
The North American-rated line cord is provided with each projector. Ensure that you
are using a line cord, socket and power plug that meets the appropriate local rating
standards.
Always power down the projector before unplugging the AC line cord – Once you
power down, wait two minutes to allow the main exhaust fan to turn off and for the
lamps to cool before unplugging the projector.
WARNINGS
Do not attempt operation if the AC supply and cord are
not within the specified voltage and power range.
Wait for the cooling fans to turn off before unplugging the
projector.
Figure 2.22. AC Line Cord Connection
2.6 Power
Connection