Filter
Top Products
Section 3: Operation
3-16 Christie DS+60/DW30/Matrix 3000 User’s Manual 013-100149-02 Rev. 1 (01/07)
All available channels are listed in the Channel Setup menu, which describes how
each channel can be accessed and which serves as the gateway for editing, copying
and deleting channels.
From the presentation
level press
Menu
to display
the Main menu. To
display the Channel Setup
menu, press
3
, or
move the highlight to the
Channel Setup option and
press
. The Channel
Setup menu will appear
(see sample at right), with
the active channel highlighted.
WHAT APPEARS IN CHANNEL SETUP MENU? This menu lists all channels defined so
far and indicates where they are connected on the input panel. The far left column lists
channel numbers currently defined. The values in the far
right columns indicate horizontal and vertical
frequencies—if someone has defined a name for this
channel, it appears here instead. Remaining columns
contain details pertaining to each channel setup, such as its
switcher number (always 0 = projector), slot location, a
variety of icons indicating access to each channel, and an abbreviated description of
each signal type. See Editing a Channel Setup for details.
NOTE: If you have more than a handful of channels, use
and to see the
remaining channels not visible in the initial display of channels.
SIGNAL TYPE — Either channel list, whether the
Channel
key list or the Channel Setup
menu, identifies signal types in a shortened form as defined below. These descriptors
indicate what signal information the projector uses to identify a match for a given
channel, and are preceded by either an “i” (interlaced signals) or “p” (progressive
signal“). See Table 3.2.
Table 3.2. Abbreviations for Signal Type
Abbrev. Signal Type
4WH Composite (4 wire) on HC input
4WV Composite (4 wire) on V input
SG Sync-on-green
5W Separate H,V
5WR Separate H,V swapped
SVid S-Vid
CVid Composite Video
Dig Digital
What Channels f
Are Defined So Far?
Figure 3.9. All Channels Appear in the
Channel Setup Menu