Filter
Top Products
Section 3: Operation
3-68 Christie DS+60/DW30/Matrix 3000 User’s Manual 013-100149-02 Rev. 1 (01/07)
should be reported to the manufacturer. You can press
Exit Exit
to remove the
message, but for best results you should reset the projector—power the projector
down and up again with the
(power) key.
System Errors
A system error message indicates that a serious malfunction has been detected and
must be reported to the manufacturer as soon as possible (see Status LED Codes,
below). The projector will no longer operate and must be reset—power the projector
down and up again with the
(power) key.
The Status LED Codes
If the status code display on the back of the projector shows one of the following
values, you have encountered a likely system error requiring the attention of a
qualified service technician (see System Warnings and System Errors, above).
Acknowledge and clear the error with
Exit
Exit
from presentation level, or try
resetting the projector by powering it off and on again, cooling when necessary.
Consult and contact your dealer if the problem persists.
The specific code number identifies the source of the error detected, and is
particularly useful in cases where the projector is too far away to read the
accompanying text message in the LED status display window. For example, the code
“27” means “Lamp 1 could not be turned on”. Error codes for this projector are listed
in the table below.