Filter
Top Products
User’s Manual vi
TOSHIBA AC100
“fring” and the fring logo are trademarks of fring. Other product names or
service marks mentioned herein may be trademarks or registered
trademarks of their respective owners and are hereby acknowledged.
Twitter is a trademark of Twitter, Inc., and is used under license.
Adobe and Adobe PDF are either registered trademarks or trademarks of
Adobe Systems Incorporated in the United States and/or other countries.
"IPA Font" is a registered trademark of IPA in Japan.
Other trademarks and registered trademarks not listed above may be used
in this manual.
AVC/H.264 License Notice
THIS PRODUCT IS LICENSED UNDER THE AVC PATENT PORTFORIO
LICENSE FOR THE PERSONAL AND NON-COMMERCIAL USE OF A
CONSUMER TO (i)ENCODE VIDEO IN COMPLIANCE WITH THE AVC
STANDARD ("AVC VIDEO") AND/OR (ii)DECODE AVC VIDEO THAT WAS
ENCODED BY A CONSUMER ENGAGED IN A PERSONAL AND NON-
COMMERCIAL ACTIVITY AND/OR WAS OBTAINED FROM A VIDEO
PROVIDER LICENSED TO PROVIDE AVC VIDEO. NO LICENSE IS
GRANTED OR SHALL BE IMPLIED FOR ANY OTHER USE.
ADDITIONAL INFORMATION MAY BE OBTAINED FROM MPEG
LA,L.L.C. SEE HTTP://WWW.MPEGLA.COM
FCC information
FCC notice "Declaration of Conformity Information"
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and receiver.
■ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
■ Consult the dealer or an experienced radio/TV technician for help.