Filter
Top Products
2 Troubleshooting Procedures
Procedure 2 Connector Check and Replacement Check
The optical drive (DVD-ROM and DVD±R/±RW/-RAM Drive) is connected to the main
board. The connectors may be disconnected from the main board or may be damaged.
Disassemble the computer following the steps described in Chapter 4, Replacement
Procedures and perform the following checks:
Check 1 Make sure the drive to test is firmly connected to CON6002 on the main board.
If the connection is loose, reconnect firmly and repeat Procedure 1. If there is still
an error, go to Check 2.
Check 2 The drive may be defective or damaged. Replace the drive with a new one. If
there is still an error, go to Check 3.
Check 3 Replace the main board with a new one following the steps in Chapter 4,
Replacement Procedures.
2-34 [CONFIDENTIAL] Satellite M500/M505/M507 Maintenance Manual