Filter
Top Products
14
Figure 3-15 Quick Setup - Wireless settings
¾ SSID - Enter a value of up to 32 characters. The same SSID must be assigned to all wireless
devices on your network. The default SSID is TP-LINK_XXXXXX This value is case-sensitive.
For example, TEST is NOT the same as test.
¾ Region - Specifies the region where the wireless function of the AP can be used. Select your
region from the drop-down list. The default is United States. If your country or region is not
listed, please contact your local government agency for assistance.
)
Note:
Restricted by local law regulations, version for North America does not have region selection
option. The wireless basic settings for this version are shown below.
¾ Channel - The current channel in use. This field determines which operating frequency will
be used.
¾ Mode - Indicates the current mode 54Mbps (802.11g), 11Mbps (802.11b). If you select
54Mbps (802.11g), it is compatible with 11Mbps (802.11b).
These settings are only for basic wireless parameters, for advanced settings, please refer to
Section 4.6: "Wireless".
B. When you choose AP mode on Quick Setup - Choose Operation Mode page (shown as
Figure 3-10), you will directly go to the Wireless page as Figure 3-15 above.
C
lick the Next button. You will then see the Finish page:
Figure 3-16 Quick Setup - Finish
After finishing all configurations of basic network parameters, please click Finish button to exit
this Quick Setup and wait your device to reboot automatically. The changes of settings will take
effect after rebooting.