Filter
Top Products
71
Figure 5-5 Wireless Settings in AP mode
¾ SSID (Set Service Identifier) - Identifies your wireless network name. Create a name up to 32
characters and make sure all wireless points in the wireless network with the same SSID.
The default SSID is TP-LINK_XXXXXX (XXXXXX indicates the last unique six characters of
each device’s MAC address). This value is case-sensitive. For example, TEST is NOT the
same as test.
¾ Region - Select your region from the pull-down list. This field specifies the region where the
wireless function of the device can be used. It may be illegal to use the wireless function of
the device in a region other than one of those specified in this field. If your country or region is
not listed, please contact your local government agency for assistance.
)
Note:
3) The default region is United States. When you select your local region from the pull-down list,
the dialog shown in Figure below appears. Click OK.
4) Restricted by local law regulations, version for North America does not have region selection
option.
Note Dialog
¾ Channel - Determines the operating frequency to be used. It is not necessary to change the
wireless channel unless you notice interference problems with another nearby access point.
¾ Power - The transmit power of the access point. The checkbox determines whether transmit
power uses high power or not. Checking the Enable High Power Mode option will help
improving the wireless performance, but may cause interference to other devices and violate
the applicable law in some areas. It’s not recommended that you enable high power mode in
areas that applicable law will be violated.
¾ Mode - Select the desired wireless mode. The options are:
• 54Mbps (802.11g) - Both 802.11g and 802.11b wireless stations can connect to the