Filter
Top Products
55
Figure 4-49 Find IP & MAC Binding Entry
Click the Enable All button to make all entries enabled.
Click the Delete All button to delete all entries.
4.12.2 ARP List
Selecting IP & MAC Binding > ARP List will enable you to observe the computers in the LAN by
checking the relationship of MAC address and IP address on the ARP list, and you could
configure the items on the ARP list also. This page displays the ARP List; it shows all the existing
IP & MAC Binding entries (shown in Figure 4-50).
Figure 4-50 ARP List
¾ MAC Address - The MAC address of the controlled computer in the LAN.
¾ IP Address - The assigned IP address of the controlled computer in the LAN.
¾ Status - Indicates whether or not the MAC and IP addresses are bound.
¾ Configure - Load or delete an item.
z Load - Load the item to the IP & MAC Binding list.
z Delete - Delete the item.
Click the Bind All button to bind all the current items, available after enable.
Click the Load All button to load all items to the IP & MAC Binding list.
Click the Refresh button to refresh all items.
)
Note:
An item could not be loaded to the IP & MAC Binding list if the IP address of the item has been
loaded before. Error warning will prompt as well. Likewise, "Load All" only loads the items without
interference to the IP & MAC Binding list.