Filter
Top Products
76
Figure 5-9 Point to Multi-point Bridge
1. Configure the Operating Mode of the TL-WA5110G 54Mbps High Power Wireless Access
Points.
• Because it is in the central location, configure TL-WA5110G (AP1) on LAN Segment 1 in
Point-to-Multi-Point Bridge mode. The MAC addresses of AP2 and AP3 are required in
AP1.
• Configure TL-WA5110G (AP2) on LAN Segment 2 in Point-to-Point Bridge mode with
the MAC Address of AP1.
• Configure the TL-WA5110G (AP3) on LAN 3 in Point-to-Point Bridge mode with the MAC
Address of AP1.
2. Verify the following parameters for all access points.
• All TL-WA5110G Access Points use the same Channel, and security settings if any.
• All Point-to-Point APs must have AP1’s MAC address in its AP MAC address field, and
AP1 must have all All Point-to-Point APs’ MAC addresses.
3. Verify connectivity across the LANs.
• A computer on any LAN segment should be able to connect to the Internet or share files
and printers with any other PCs or servers connected to any of the three LAN segments.
Wireless stations will not be able to connect to the TL-WA5110G 54Mbps High Power Wireless
Access Points in the illustration above. If you require wireless stations to access any LAN
segment, you can add TL-WA5110G 54Mbps High Power Wireless Access Points configured in
Wireless Access Point mode to any LAN segment.
)
Note:
1) You can extend this multi-point bridging by adding additional TL-WA5110Gs configured in
Point-to-Point mode for each additional LAN segment. Furthermore, you can extend the