Filter
Top Products
34
4.6.8 Throughput Monitor
Selecting Wireless > Throughput Monitor will helps to watch wireless throughput information in
the following screen shown in Figure 4-20.
Figure 4-20 Wireless Throughput
¾ Rate - The Throughput unit.
¾ Run Time - How long this function is running.
¾ Transmit- Wireless transmit rate information.
¾ Receive- Wireless receive rate information.
Click the Start button to start wireless throughput monitor.
Click the Stop button to stop wireless throughput monitor.
4.7 DHCP
DHCP stands for Dynamic Host Configuration Protocol. The DHCP Server will automatically
assign dynamic IP addresses to the computers on the network. This protocol simplifies network
management and allows new wireless devices to receive IP addresses automatically without the
need to manually assign new IP addresses.
There are three submenus under the DHCP menu (shown as Figure 4-21): DHCP Settings,
DHCP Clients List and Address Re
servation. Clicking any of them will enable you to configure
the corresponding function. The detailed explanations for each submenu are provided below.