Filter
Top Products
28 Chapter 3
• Delay before repeat - Repeat parameters for held-down key. Delay before repeat
selectable from 1/5 second to 2 seconds, or no repeat. The default is 1/3 second.
• Repeat Rate - Select Slow, Medium, or Fast. The default is Medium.
Configuring Network Settings
The Network Setup dialog box allows you to configure thin client network settings
(including operation in modem dialup and PPPoE modes, as well as locations of servers
essential to thin client operation).
Note
If required by the operating environment, the network administrator may
disable access to this dialog box. Specifically, it cannot be accessed by
Non-privileged and Low-privileged users (and not until after log on if using
dial-up or PPPoE access). In addition, if the network administrator has set
the lockdown mode by means of an entry in the user profile, both system
reset and access to this dialog box are disabled for Stand-alone users as
well.
For more information about system lockdown, refer to "Understanding System
Lock-down."
Figure 12 Network Setup - General tab
Use the following guidelines:
• Ethernet Speed - Normally the default (Auto-Detect) should be selected, but another
selection can be made if automatic negotiation is not supported by your network
equipment. Selections include Auto-Detect, 10 Mb Half-Duplex, 10 Mb Full-Duplex,
100 Mb Half-Duplex, 100 Mb Full-Duplex.
Note
The 10 Mb Full-Duplex option can be selected locally at the device,
however, this mode may need to be negotiated through Auto-Detect.