Filter
Top Products
i
Safety
Safety Introduction
Notices and Safety
Please read the following instructions carefully before operating the
machine and refer to them as needed to ensure the continued safe
operation of your machine.
Your Xerox product and supplies have been designed and tested to meet
strict safety requirements. These include safety agency evaluation and
certification, and compliance with electromagnetic regulations and
established environmental standards.
The safety and environment testing and performance of this product have
been verified using Xerox materials only.
WARNING
: Unauthorized alterations, which may include the addition of
new functions or connection of external devices, may impact the product
certification. Please contact your Xerox representative for more
information.
Marks and Labels
Symbols
All warnings and instructions marked on or supplied with the product
should be followed.
WARNING
: This symbol alerts users to areas of the equipment
where there is the possibility of personal injury.
WARNING
: This symbol alerts users to areas of the equipment
where there are heated or hot surfaces, which should not be
touched.
CAUTION
: This symbol alerts users to areas of the equipment
which require special attention to avoid the possibility of
personal injury or damage to the equipment.
WARNING
: This symbol indicates a Laser is being used in the
equipment and alerts the user to refer to the appropriate safety
information.
NOTE
: This symbol identifies information that is being
emphasized and is important for you to remember.
Radio Frequency Emissions
FCC Notices For The USA
NOTE
: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not specifically approved by
the Xerox Corporation may void the user's authority to operate this
equipment.
EME Compliance for Canada
This Class "B" digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe « B » est conforme à la norme
NMB-003 du Canada.
Laser Safety Introduction
Laser Safety
CAUTION
: Use of controls, adjustments, or performance of
procedures other than those specified in this guide may result in
hazardous light exposure.
This equipment complies with international safety standards
and is classified as a Class 1 Laser Product.
With specific reference to lasers, the equipment complies with
laser product performance standards set by governmental,
national, and international agencies as a Class 1 Laser Product.
It does not emit hazardous light, as the beam is totally enclosed
during all phases of customer operation and maintenance.
Operational Safety Information
Operational Safety Information
Your Xerox equipment and supplies have been designed and tested to
meet strict safety requirements. These include safety agency
examination, approval, and compliance with established environmental
standards.