Filter
Top Products
Network Configuration
WorkCentre 6400 Multifunction Printer
System Administrator Guide
30
4. Type the IP address of the host running the SNMP manager application to be used to receive
traps.
Note: Port 162/UDP is the default port for traps. You can select v1 or v2c based on what the trap
receiving system supports.
5. Under Traps, select the type of Traps to be Received by the SNMP manager.
6. Click Save to accept the new settings or Undo to retain the previous settings.
7. Click Apply.
8. Click OK.
Adding IPX Trap Destination Addresses
Internetwork Packet eXchange (IPX) is a routing protocol used by Novell NetWare environments.
Note: If your printer is locked, you must log in as a system administrator. For details, see Accessing
CentreWare IS on page 17.
1. In CentreWare IS, click Properties > Connectivity > Protocols > SNMP.
2. Click Advanced Settings at the bottom of the page.
3. Under Trap Destination Addresses, click Add IPX Address.
4. Type the 8-digit hexadecimal number that identifies the IPX External Network host configured to
receive the trap.
5. Type the 48-bit Physical MAC Address of the computer running the SMNP manager application
that is to receive the trap.
6. Type the IPX Socket Number of the computer running the SNMP manager application configured
to receive the packets.
7. Under Traps, select the type of Traps to be Received by the SNMP manager.