Filter
Top Products
XES Synergix 8825/8830/8850/8855 Digital Solution User Guide 4
Getting to know the Synergix Digital Solution (continued)
Document Feed Tray
Insert documents to be scanned face down and centered into the Document
Feed Tray.
Document Handler
Raise the Document Handler for routine maintenance functions and to
access the optical paper sensors for diagnostic routines.
Scanner Control Panel
The control panel allows the selection of options and features and contains a
graphical display for the communication of information and instructions. Refer
to Scanner Control Panel on the following page for additional information.
Thick Document Lever
The Thick Document Lever is used to adjust the Scanner for thick documents
and to remove documents from the Scanner feed mechanism. When setting
the thickness for a document, raise the lever to the next thickness. If the
document slides past the Feed Rolls into the Document Handler, lower the
Lever to the next position.
Standard Organizer
The Organizer is located on the front of the Scanner. It is useful for holding
multiple documents that are to be scanned. It has two extensions at its end
that can be pulled out to accommodate longer documents (up to size E or
A0).
IEEE 1394 Cable and Connector
The IEEE 1394 Cable is the communications link between the Scanner and
the Controller. Plug one end of the cable into either one of the IEEE 1394
connections at the rear of the Scanner. Plug the other end into the IEEE
1394 connection on the Controller.
Standard Stacker
The Stacker is located at the rear of the Scanner. When the AUTORETURN
feature is set to REAR, documents exit the Scanner onto the Stacker. The
Stacker can be adjusted to any one of four positions by raising or lowering it.
The height of the Stacker should be adjusted to accommodate the document
being scanned. It has two extensions at its end that can be pulled out to
accommodate longer documents (up to size E or A0). When scanning most
common weight (20 lb, 80gsm) documents, move the Stacker to the 2
nd
rung
from the bottom.
NOTE: All thick documents exit from the rear of the Scanner (regardless of
the AUTORETURN setting). When scanning thick documents, the Stacker
must be set to the lowest position for optimum performance.
Document Exit Slot
When the DOCUMENT RETURN feature is set to REAR, documents exit the
Scanner through this slot and are delivered to the rear Stacker.
Status LED
The digital status LED provides an indication of the condition of the scanner
and communications with the controller. A P. display indicates that the
scanner is operating normally and has established communications with the
controller.
Power On/Off Switch
This switch turns the Scanner on and off. Press this switch to the on (I)
position to turn on the Scanner and to the off (O) position to turn off the
Scanner.
Power Cord and Connector
The Power Cord supplies power to the Scanner. Plug one end of the cord
into the Scanner and the other end into an electrical outlet.
Stand
The Stand is standard with the XES Synergix 8825 and 8830 Digital Solution,
and optional with the XES Synergix 8855 Digital Solution.