Filter
Top Products
Configuration
Control Panel LCD Display
64
13290L-001 Rev. A S4M User Guide 10/21/05
CONTROL CODES
(APL-D mode only)
Set APL-D Control Codes
Selections: STANDARD, MAINFRAME
Default Value: STANDARD
To modify this parameter:
• Press the up or down arrow to scroll through the selections.
MODULE A
(APL-D mode only)
Set Module A Storage Device for APL-D
Selections: NONE, RAM 1, RAM 2, FLASH 1, FLASH 2
Default Value: NONE
To modify this parameter:
• Press the up or down arrow to scroll through the selections.
MODULE B
(APL-D mode only)
Set Module B Storage Device for APL-D
Selections: NONE, RAM 1, RAM 2, FLASH 1, FLASH 2
Default Value: NONE
To modify this parameter:
• Press the up or down arrow to scroll through the selections.
RESOLUTION
(APL-I mode only)
Set Printer Resolution for APL-I
Sets the dot size for backward compatibility with some older APL-I
printers.
Selections: 5 MIL, 10 MIL, 15 MIL
Default Value: 5 MIL
To modify this parameter:
• Press the up or down arrow to scroll through the selections.
LENGTH
Set Maximum Label Length
Maximum label length is used in conjunction with the calibration
procedure. The value of this setting is the maximum label length that is
used during the media portion of the calibration process. Only a few labels
are required to set media sensors. Always set the value that is at least 1 in.
(25.4 mm) longer than the longest label to be used on the printer.
Selections:
AUTO, < 1 INCH (25.4 mm) to < 39 INCH (991 mm)
Default Value:
AUTO
To modify this parameter:
• To increase the value, press the up arrow.
• To decrease the value, press the down arrow.
Table 10 • Printer Parameters, Password Levels 1 and 2 (Page 5 of 5)
Parameter Explanation