Filter
Top Products
Chapter 27 Product Specifications and Wall-Mounting Instructions
NBG-460N User’s Guide
317
Wall-mounting Instructions
Do the following to hang your NBG-460N on a wall.
Note: See the Figure 190 on page 318 for the size of screws to use and how far apart
to place them.
1 Locate a high position on a wall that is free of obstructions. Use a sturdy wall.
2 Drill two holes for the screws. Make sure the distance between the centers of the
holes matches what is listed in the product specifications appendix.
Be careful to avoid damaging pipes or cables located inside the
wall when drilling holes for the screws.
3 Do not screw the screws all the way into the wall. Leave a small gap of about 0.5
cm between the heads of the screws and the wall.
4 Make sure the screws are snugly fastened to the wall. They need to hold the
weight of the NBG-460N with the connection cables.
5 Align the holes on the back of the NBG-460N with the screws on the wall. Hang
the NBG-460N on the screws.
Figure 189 Wall-mounting Example
IEEE 802.11x Port Based Network Access Control.
IEEE 802.11e QoS IEEE 802.11 e Wireless LAN for Quality of Service
Microsoft PPTP MS PPTP (Microsoft's implementation of Point to Point Tunneling
Protocol)
MBM v2 Media Bandwidth Management v2
Table 121 Standards Supported (continued)
STANDARD DESCRIPTION