Filter
Top Products
ZyWALL 2 Series User’s Guide
23-10 WAN and Dial Backup Setup
Table 23-6 Menu 11.3: Remote Node Network Layer Options
FIELD DESCRIPTION EXAMPLE
Network
Address
Translation
Network Address Translation (NAT) allows the translation of an Internet
protocol address used within one network (for example a private IP
address used in a local network) to a different IP address known within
another network (for example a public IP address used on the Internet).
Press [SPACE BAR] and then [ENTER] to select either Full Feature, None
or SUA Only.
Choose None to disable NAT.
Choose SUA Only if you have a single public IP address. SUA (Single
User Account) is a subset of NAT that supports two types of mapping:
Many-to-One and Server.
Choose Full Feature if you have multiple public IP addresses. Full
Feature mapping types include: One-to-One, Many-to-One (SUA/PAT),
Many-to-Many Overload, Many- One-to-One and Server. When you
select Full Feature you must configure at least one address mapping set!
See the Network Address Translation (NAT) chapter for a full discussion on
this feature.
None
(default)
Metric Enter a number from 1 to 15 to set this route’s priority among the
ZyWALL’s routes. The smaller the number, the higher priority the route
has.
15
(default)
Private This parameter determines if the ZyWALL will include the route to this
remote node in its RIP broadcasts. If set to Yes, this route is kept private
and not included in RIP broadcasts. If No, the route to this remote node will
be propagated to other hosts through RIP broadcasts.
No
(default)
RIP
Direction
Press [SPACE BAR] and then [ENTER] to select the RIP Direction from
Both/ None/In Only/Out Only and None.
Both
(default)
Version
Press [SPACE BAR] and then [ENTER] to select the RIP version from RIP-
1/RIP-2B/RIP-2M.
RIP-1
Multicast IGMP (Internet Group Multicast Protocol) is a session-layer protocol used
to establish membership in a Multicast group. The ZyWALL supports both
IGMP version 1 (IGMP-v1) and version 2 (IGMP-v2). Press the [SPACE
BAR] to enable IP Multicasting or select None to disable it. See the LAN
Setup chapter for more information on this feature.
None
(default)
Once you have completed filling in Menu 11.3 Remote Node Network Layer Options, press [ENTER] at
the message “Press ENTER to Confirm...” to save your configuration and return to menu 11, or press [ESC]
at any time to cancel.