The Harmonizer
Programmer’s Manual
The Harmonizer
Programmer’s Manual Page 53 of 97 Release 1.2.1
1999 Eventide, Inc.
Double click on the hmonitor monitor and change
the specifiers as shown to the right.
• Audio and mod signals range from -1 to +1. In this
case, the LFO’s output is only varying from zero to
+1 and so we set the minimum and maximum on the
monitor accordingly.
Constructing the Menu Page
OK, the hard stuff is over. All of the elements are there, we just
need to place them on a menu page. To the right is a sneak peak
at what we will end up with. Notice that the parameters on the
right side of the menu page pertain to the modulation
rate and shape, while the parameters on the left side of
the menu page pertain to everything else. This is a
good, functional arrangement.
Add a menupage module from the “Interface” group
and connect its userobject output to the head module.
Then double click on the menupage module and
change the specifiers as shown to the right.
• The description “Ch 1 Flanger” will be displayed in the upper right corner of the Harmonizer’s display.
• The 8 char name will be used on the menu page’s
SOFT KEY.
Now we’re ready
to connect the
userobject outputs
from the various
“parameter
adjusters” to the
menupage
module. The order
that we connect
them is the order
they will appear on
the menu page.
We’ll connect them
in the order shown
to the right:
1. strgth knob 1
2. feedback knob 1
3. depth knob 1
4. rate knob 1
5. wave select 1
6. duty knob 1
7. sweep mon 1
