The Harmonizer
Programmer’s Manual
The Harmonizer
Programmer’s Manual Page 76 of 97 Release 1.2.1
1999 Eventide, Inc.
THE <MODIFY>
SOFT KEY
The <modify> SOFT KEY gives you the ability to directly change the “internals” of a module. This is
necessary to create complex, highly customized programs. The
<modify> SOFT KEY works on one module
at a time and is needed to change the following:
• the module name
• specifiers
• connections between userobjects and userobject inputs
• control inputs that are not “patched” and that are not controlled via their userobject
Modifying a delay module
To use the <modify> SOFT KEY in the Patch Editor display, simply
select the desired module using the
LEFT and RIGHT CURSOR
control keys. . .
. . .and then press the
<modify> SOFT KEY. On entry to the
<modify> menu, the display shows the current KNOB mode
(
select or adjust), the name of the module, the module type, and
the first three lines of module information.
The
<modify> menu scrolls and behaves much like things in the PROGRAM area do.
• To scroll through the data for the module use the
CURSOR
keys. If the
KNOB mode reads (select) (as shown to the right) you
can also use the
KNOB to scroll through the data for the
module.
• To change any of the data in the module, first ensure that the
line of data you want to change is highlighted and that the
KNOB mode reads (adjust) (these two requirements are actually one in the
same)
. You highlight a line by either pressing the RIGHT or
DOWN CURSOR key OR by pressing the SELECT key.
• Once a line of data is highlighted, spin the
KNOB or use the
numeric keypad to adjust the data. A pop-up menu appears
that prompts you to either press the
SELECT key or the ENT
key when you are satisfied with the change.
Below is a composite of the information for the first delay module in the
Patch Instruct program.
