The Harmonizer
Programmer’s Manual
The Harmonizer
Programmer’s Manual Page 72 of 97 Release 1.2.1
1999 Eventide, Inc.
If you press the <aud only> SOFT KEY to go to the aud+ctrl
display mode, you'll see the knobs and monitor that make the
Each delay and Delay Amount parameters shown in the
PARAMETER area work. Notice the mul module. That's a
c_multiply module. It is multiplying the control signal from the knob (
knb) module by a constant
amount
(in this case 2 -but you can’t see it in this display) and feeding the result to the monitor (mon) module.
Go back to the
PARAMETER area (by pressing and holding the PARAMETER
key)
to see how these modules and their connections in the Patch
Editor area translate into parameters on a menu page. The
monitor module creates the parameter Delay Amount that
shows the actual delay, while the knob creates the parameter
Each
delay
that sets the delay for each of the delay modules.
For the sake of demonstration, we'll use the <connect> SOFT KEY to rearrange the delay (dly) modules
such that one is in “channel” 1 and the other is in “channel” 2, thus delaying each “channel” by up to 10
seconds (10,000mS).
(Hey! Ya gotta crawl before you can run, OK?)
Press the PROGRAM key and reload Patch Instruct. After the program is loaded, press and hold the
PARAMETER key to re-enter the Patch Editor area.
Press the <aud only> SOFT KEY to get the screen shown to the
right.
Now press the
<connect> SOFT KEY. The Harmonizer will
prompt for something to connect.
Using the
CURSOR keys, select the output of the leftmost dly
module. You'll know you have the correct output when the upper
right of the display reads first delay-out. When the screen looks
like the one shown to the right, press the
SELECT key.
