The Harmonizer
Programmer’s Manual
The Harmonizer
Programmer’s Manual Page 92 of 97 Release 1.2.1
1999 Eventide, Inc.
PARAMETER AREA MENU PAGE PLACEMENT
This section goes through a tutorial to show:
• Certain modules that have userobject outputs are automatically connected to the head module upon
<insert>ion.
• The order of userobject connection to the head module affects
SOFT KEY location in the PARAMETER
area.
• A null userobject connected to the head module or a menupage module does not appear in the
PARAMETER area menu pages, but rather acts as a place holder.
Start with a “clean slate”
• Load Empty Program from the “Utilities” bank.
• Go to the Patch Editor area
(by pressing and holding the PARAMETER
key)
• Select the
misc display mode by pressing the <aud only>
SOFT KEY three times. Select the module marked hed with
the
LEFT or RIGHT CURSOR key. Press the <modify> SOFT
KEY
. To the right is a composite image of what the
<modify> menu looks like for the head module at this time.
Automatically connecting a userobject to the head module
• Press the <done> SOFT KEY to leave the <modify> menu for the head module. Press the <misc>
SOFT KEY twice to select the aud+ctrl display mode.
• Press the
<insert> SOFT KEY and then the LEFT CURSOR
key. Turn the
KNOB until the “Delay” group is shown.
Press the
RIGHT CURSOR key to highlight the allpass
module.
• Press the
SELECT key to go ahead with the insertion.
• Press and hold the
PARAMETER key to see that there is now a
menu page and
SOFT KEY for the allpass module.
• Go back to the Patch Editor area and select the
misc display
mode and use the
<modify> SOFT KEY on the head
module. This is a composite of what the
<modify> SOFT
KEY
can see in the head module now. This shows that the
allpass-obj userobject was automatically connected to the head
module.
