The Harmonizer
Programmer’s Manual
The Harmonizer
Programmer’s Manual Page 94 of 97 Release 1.2.1
1999 Eventide, Inc.
• So that we can differentiate this menupage module from the
next one we insert, use the
<modify> SOFT KEY on it and change
its
name to “1menupage." Do this by selecting the name
specifier, pressing the
SELECT key, turning the KNOB right until the
highlighted line reads “
1menupage." and pressing the SELECT
key.
After you’ve changed the
name, press the<done> SOFT KEY and
note that the module name is displayed in the upper right corner of
the screen.
• Select the
aud+ctrl display mode.
•
<insert> a meter module from the “Interface” group.
• Go back to the
misc display mode and use the <modify>
SOFT KEY on the menupage module. (Use the LEFT or
RIGHT CURSOR key to choose the menupage module.)
• Set the
# entries specifier to 1 and then set the obj1 specifier to
meter-obj. Make sure you use the SELECT key to save each
change. Press the
<done> SOFT KEY to exit from the <modify> menu.
• Use the
<modify> SOFT KEY on the head (hed) module.
Change its
# entries parameter to 1 (if it isn’t already) and set
obj1 to 1menupage-obj.
• Return to the
PARAMETER area and observe the menu page.
Note that it has one meter module monitor. Note also that
the
SOFT KEY is not stacked and that the menu page’s title is
“
menupage."
• Go back to the Patch Editor,
misc display mode and use the
<modify> SOFT KEY on the menupage module.
• Set the
# entries specifier to 2 and then set the obj2 specifier to
meter-obj (same as obj1).
