The Harmonizer
Programmer’s Manual
The Harmonizer
Programmer’s Manual Page 66 of 97 Release 1.2.1
1999 Eventide, Inc.
The display to the right shows the ducker highlighted, with its
output selected and its sidechain input ready to be selected.
Press the
SELECT key.
There you have it. There’s a wire connecting the ducker’s
output to its sidechain input.
Now let’s connect the ducker’s
main input to the IN module.
Press the
<connect> SOFT KEY and then the LEFT CURSOR key
twice. The ducker’s
main input should be highlighted as
shown to the right.
Press the
SELECT key to actually select the ducker’s main
input
. Now we need to select something to connect the
ducker’s
main input to. As luck would have it, the IN
module’s
input 1 is the currently selected candidate.
Press the
SELECT key to complete the connection.
The last thing we need to do is connect the OUT module to the
ducker so that we can hear what the compressor sounds like.
Press the <connect> SOFT KEY and then the SELECT key to select
the ducker’s
output. Press the SELECT key again to connect
that to the OUT’s
output 1.
Now the compressor will be heard on the first “channel” of the
DSP running the program, while the remaining three “channels” go
uncompressed. Press and hold the PARAMETER key to see the
ducker module’s menu page.
Now that you’re somewhat familiar with the mechanics of inserting and hooking modules up, let’s move on
to something a little more comprehensive.
